Autoquip HORIZONTAL BALL SCREW - Manual (Page 3)

IDENTIFICATION & INSPECTION
IDENTIFICATION
When ordering parts or requesting information or service on this equipment, PLEASE
REFER TO THE MODEL AND SERIAL NUMBER. This information is on a nameplate
attached to the leg assembly. Replacement parts are available from a local Autoquip
distributor.
INSPECTION
Immediately upon receipt of the unit, a visual inspection should be made to determine
that it has not been damaged in transit. Any damage found must be noted on the
delivery receipt. In addition to this preliminary inspection, the unit should be carefully
inspected for concealed damage. Any concealed damage found that was not noted on
the delivery receipt should be reported in writing to the delivering carrier within 48 hours.
The following is a checklist that will aid in the inspection of this equipment.
1. Examine the entire unit for any signs of mishandling.
2. Pay special attention to gearboxes, mechanical actuators & wiring.
3. After installation, raise and block the lift and inspect the base frame, scissors
assembly and mechanical drive system. See the “Lift Blocking Instructions” section.
3