Autoquip HORIZONTAL BALL SCREW - Manual (Page 16)

DANGER !
INSTALLATION INSTRUCTIONS
Do not work under lift without Maintenance Device! To avoid personal
injury, NEVER go under the lift platform until the load is removed and the
scissors mechanism is securely blocked in the open position. See "Lift
Blocking Instructions" section.
6. The base frame of the lift has pre-drilled holes for lagging the lift securely to the
floor. Mark holes, drill, and install with anchors. Lifts with oversize platforms have
minimum pull out requirements of 2,000 lbs. for each anchor.
7. Make the permanent electrical connections and operate the lift through a few cycles.
8. Apply all warning labels in the correct location. See “Label Identification” section.
9. Clean up any debris from the area. A clean installation makes a good impression
and creates a much safer environment!
16