Enclosure installation (cont.) – Autoquip GATES SLIDING User Manual
Page 10
9
ENCLOSURE INSTALLATION (Cont.)
___________________________________________________________
3. On the sides, the panels will butt together and attach through the enclosure angles, using TEK
screws.
4. Continue around lift until you have completed the enclosures. NOTE: If space allows, you can
assemble each side, then stand the completed side up.
5. Across the top of the enclosure panel, mount the 12” long stiffener channel supplied, and attach
using TEK screws. (See figure 8)
Stiffener
Channel
(
centered
)
FIGURE 8
6. The next step is to brace the enclosure back to the lift.
THIS BRACING IS SUPPLIED BY
THE INSTALLER.
When installing bracing, make sure that it does not interfere with any moving
components of the Lift or gates.
7. Lag all the mounting feet, on the enclosures, to the floor.
8. You can now mount the interlocks according to the instructions.