Anchor 5-STAR SOLID SAFETY POOL COVER - Manual (Page 10)

OPTIONAL CABLE ASSEMBLY INSTALLATION
1) Install 3/8” drop-in anchor with 3/8” eyebolt on one end of cable area. Install 3/8” drop in anchors at the opposite end of
the cable area and approximately 18” apart for the 3/8” cable anchor bolts. See FIG.11A.
2) When installing the cable anchor bolt to the cable area, align the hole in the anchor bolt in the direction of the cable.
See FIG. 11B. Run the cable through the in-line holes. see FIG. 11C. Run one end of the cable through the cable anchor
at one end of cable area and loop. Attach (2) cable clamps and tightly secure cable, see FIG. 11B. Run other end of
cable through eyebolt on turnbuckle, make loop and attach (1) cable clamp for now. With turnbuckle fully extended out,
attach hook end of turnbuckle to the eyebolt at the end of the cable area. Loosen the (1) cable clamp and pull cable as
taut as possible. Tighten (1) cable clamp and add second cable clamp now. Be sure all cable clamps are tight to secure
the cable. Rotate mid-section of turnbuckle to tighten cable further, see FIG. 11D.
3) Attach the snaps located under pool cover in cable area onto cable. See FIG. 11E.
NOTE: This application of cable is for a standard straight wall installation. A custom cable area may require special
installation and hardware. If you have any questions call your Anchor Representative to assist you.
Install cable hardware at the same level as the rest of the cover!
3/16” STAINLESS
STEEL CABLE
TURNBUCKLE
CABLE CLAMP
3/8” SLOTTED CABLE ANCHOR
BOLT AND DROP-IN ANCHOR
3/8” MACHINE THREADED
EYEBOLT AND DROP-IN ANCHOR
SETTING TOOL
10
HARDWARE