Allworx Tx 92/24 - Manual (Page 6)

Tx 92/24 Telephone Expander Installation Guide
___________________________________________________________________________________________________________________
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2012 Allworx Corp, a Windstream company. All rights reserved. All other names may be trademarks or registered trademarks of their respective
owners.
Revised: May 31, 2012
Page 4
5. Connect the ribbon cable from the telephone expander to the phone’s telephone expander connector.
6. Rotate the telephone expander down until it sits on the phone.
7. Secure the telephone expander to the phone back using the three screws (see picture below).
8. Repeat steps 4 through 6 for each additional telephone expander to be connected, where each
additional telephone expander will be connected to the previous expander.
9. Attach the telephone expander cover to the back side of the last telephone expander. Secure with two
(2) screws.
2.2 Base Assembly and Adjusting the Angle (optional)
You can adjust the angle of the phone and telephone expander(s) on their bases so that it is easy to use and
easy to read the screen.
1. Lay the connected phone and telephone expander(s) face down on a soft surface with top of the phone
pointed away from you.
2. Each of the bases will connect to the back of the phone and telephone expander(s) in one of three
positions, thus allowing the phone with the telephone expander(s) to be adjusted at different angles
when sitting on a desktop. The nearest set of holes to you provides the steepest angle.
3. Notice that the bases have both fixed and flexible tabs. Hold the base with the tabs pointed away, fixed
tabs down and flexible tabs up.
4. Place the fixed tabs in the desired holes on the back of the phone and telephone expander(s).
5. Rotate the base until the flexible tabs click into place.
To remove the bases:
1. Press down on the flexible tabs and release them from their holes.