Allen&Heath ME-U - Manual (Page 13)

User Guide – AP9209_1 13 ALLEN & HEATH
8.4 The Status page
This page shows information about the ME-U.
It lets you check the current status of the hub,
its input source and connected ME-1 units:
Firmware – The current operating firmware
running in the ME-U.
 Check the Allen & Heath web site for the
latest version available.
Temperature – The current operating
temperature measured inside the unit.
 If this reads higher than 35 degrees C
then check that there is adequate airflow
around the unit and that its ventilation
slots are not blocked.
Audio Source – Displays the Input card type
and information on the source connected to
the ME-U. The following will display
depending on input card fitted and source:
 ME-D dSNAKE/ACE
 ME-D Aviom
® (Aviom source recognised)
 Dante Option Card
 MADI Option Card
 EtherSound Option Card
 ACE Option Card (not typical – use ME-D)
Source Mode – ‘iLive’ will appear if the ME-U
has been set to work with iLive. In this mode
the ME-U attempts to find channel names and
stereo link information from the iLive.
 iLive mode should only be set if you are
working with an iLive system. For all other
sources turn this mode off using the
System Setup page.
iDR Mix Rack – This displays the name of the
unit the ME-U attempts to connect to when
set to work with iLive. This information does
not appear if iLive mode is turned off.
Source Clock Sync – The box is ticked if the
ME-U audio clock has synchronised to the
source.
Port Status – Displays the current
connection status of each of the 10 output
ports:
Ethernet Linked –The box is ticked if a
network connection to a ME-1 mixer has
been recognised.
PoE Active – The box is ticked if the port is
supplying power over the Cat5 cable to the
ME-1 mixer.