Allen&Heath ICE-16 - Manual (Page 32)

Allen & Heath 32 ICE-16 User Guide
SYNCHRONISING MORE THAN ONE ICE-16
2. Plug in your USB memory devices to the master and slave ICE-16 units.
3. Switch on both ICE-16s. CON will be dis-
played when the units are first connected. The
master should display “nAS” alternating with
the Song number.
4. The slave unit should display “S-x” where x is
the slave unit number, alternating with the Song
number.
5. Press REC on the master unit to start both
units in record mode.
The master unit will display the “spinning” first
segment and the song number alternately with
“nAS”. Plus every 30 seconds the time remain-
ing will be displayed.
6. The slave device will display a “spinning” first
segment and the song number alternately with
the slave unit number. Plus every 30 seconds
the time remaining will be displayed.
7. In record mode, the transport keys on the
slave unit will be locked and if pressed will dis-
play the number of the slave unit.
8. To stop the recording press PLAY/STOP. To start the next recording, wait for the record
light to stop flashing (when stopping a previous recording) then press REC.
9. The audio files on the USB memory devices for each corresponding song will be stored as
chan_01 to chan_16. These can be re-named as preferred when copying to a computer.
10. To delete a song, select using the PREV and NEXT keys on the master ICE-16, the song
should also be selected on the slave unit (follows the master selection). Press DEL on the
master and press PLAY/STOP to confirm on both master and slave units.
30s
30s