Power-up configuration modes – Allen&Heath GS-R24M User Manual
Page 35
Allen & Heath 35 GS_R24 User Guide
POWER-UP CONFIGURATION MODES
Power the console ON whilst holding down PLAY
MIDI Operation modes
It is possible to set GS-R24 to work in different ways depending on preference and the capability of externally connected
equipment. These modes are primarily concerned with setting up the illumination of the Solo Select switch LEDs so that they
tally entirely from the console function or from external MIDI messages received by the console. The modes can also set a tick
message which is required when translating the GS-R24 default MIDI code into the HUI protocol, change the transport from
MMC to note on/off, and set the console into self test or demo mode.
To Set the configuration mode:
Release PLAY and press one of the following Solo/SEL buttons
At this stage the Solo/Select switch LEDs will display the current mode status.
SEL switch
Mode
1
Default MIDI, Internal tally, press/release = note on/off
2
Default MIDI, Internal tally, press once for note on, press again for note off
3
Default MIDI, External tally, press/release = note on/off
4
Default MIDI, External tally, press once for note on, press again for note off
5
REAPER Mode (Pending Controller plug-in becoming available)
6
Default MIDI, External tally, HUI tick ON. For translating to HUI protocol.
7 US
2400
Emulation
8 Test
&
Demo
mode.
17
On = Transport=Note On/Off. Off = Transport=MMC
To Set the MIDI Channel number:
Power the console ON whilst holding down REC
Release REC and press one of the following Solo/SEL buttons
SEL switch
Mode
1 MIDI
channel
1
2 MIDI
channel
2
3 MIDI
channel
3
4 MIDI
channel
4
5 MIDI
channel
5
6 MIDI
channel
6
7 MIDI
channel
7
8 MIDI
channel
8
9 MIDI
channel
9
10
MIDI
channel
10
11
MIDI
channel
11
12
MIDI
channel
12
13
MIDI
channel
13
14
MIDI
channel
14
15
MIDI
channel
15
16
MIDI
channel
16
Press STOP and the configuration mode is set
Press STOP and the MIDI channel number is set