Allen&Heath GS-R24M - Manual (Page 24)

Allen & Heath 24 GS_R24 User Guide
STUDIO OUTPUTS (ARTISTS FEEDS)
STUDIO
1
5-6
+6
+6
Aux 2
Aux 1
+6
+6
Stereo
4/6
3/5
Aux
Aux
+6
Stereo
1-2
Grp
+6
3-4
Grp
Stereo
+6
+6
L-R
M
10
-30
-20
-5
0
5
-10
LEV
10
-30
-20
-5
0
5
-10
LEV
AFL
STUDIO
2
5-6
+6
+6
Aux 2
Aux 1
+6
+6
Stereo
4/6
3/5
Aux
Aux
+6
Stereo
1-2
Grp
+6
3-4
Grp
Stereo
+6
+6
L-R
M
AFL
REAR PANEL CONNECTIONS
Studio feed Output Jack Socket
Standard 1/4” (6.25mm) Jack sockets for Studio artists feed output signals.
Wired Tip=Hot(+), Ring=Cold(0V), Sleeve=Chassis. Nominal level is
0dBu. Each Studio Output pair can be used as a stereo feed or two mono
outputs.
FRONT PANEL CONTROLS
Studio feed submix Aux 1 level control
Sends signal from the Aux 1 mix master (post Aux 1 master level) to the
Studio L & R outputs. The control adjusts the level from fully attenuated
to +6dB gain.
Studio feed submix Aux 2 level control
Sends signal from the Aux 2 mix master (post Aux 2 master level) to the
Studio L & R outputs.
Studio feed submix Aux 3/5 level control & 5-6 switch
Sends signal from the Aux 3 mix master (post Aux 3 master level) to the
Studio L & R outputs. If the 5-6 switch is pressed then this becomes a
send from Aux 5.
Studio feed submix Aux 4/6 level control & 5-6 switch
Sends signal from the Aux 4 mix master (post Aux 4 master level) to the
Studio L & R outputs. If the 5-6 switch is pressed then this becomes a
send from Aux 6.
Studio feed Grp 1-2 level control & Stereo switch
Sends signals from the Group 1 & 2 mix (post group faders) to the Studio
L & R outputs. Normally both groups 1 & 2 are sent to both L & R studio
outputs, but if the Stereo switch is pressed group 1 feeds the left output
only and group 2 feeds only the right.
Studio feed Grp 3-4 level control & Stereo switch
Sends signals from the Group 3 & 4 mix (post group faders) to the Studio
L & R outputs. Normally both groups 3 & 4 are sent to both L & R studio
outputs, but if the Stereo switch is pressed group 3 feeds the left output
only and group 4 feeds only the right.
Studio feed L-R level control & Stereo switch
Sends signals from the main L-R mix (post main faders) to the Studio L &
R outputs. Normally both L & R are sent to both L & R studio outputs,
but if the Stereo switch is pressed mix Left feeds the left output only and
mix Right feeds only the right output.
Studio feed submix Mono mix level control
Sends signal from the master Mono mix (post master fader) to the Studio
L & R outputs.
Studio feed submix master level control
Controls the overall level of the Studio Output submix from off (fully
attenuated) to +10db gain.
Studio Output AFL
An After Fade Listen switch to select the post Level control left & right
Studio outputs to the AFL monitoring system in stereo.
A full description of the monitoring system is given on page 29.
R
STUDIO OUT 2
L
R
L
STUDIO OUT 1