Allen&Heath FireWire Interface - Manual (Page 10)

Allen & Heath 10 GS_R24 FireWire/ADAT Module User Guide
MODULE FITTING INSTRUCTIONS
Beware of ESD! Observe anti-static handling precautions—avoid touching the electronic devices on
the circuit board, ensure any static build up is discharged to earth before handling the module.
This can be achieved by ensuring the console is connected to the psu and the psu is plugged in to a
mains outlet but switched OFF, then touching a metal part of the console panel such as a screw head.
Remove 2 x screws
Remove the blanking panel at the
rear of the console by removing
the two screws.
Locate the module circuit board
in the plastic guide slots within
the housing.
Slide the module into the housing
and push firmly to insert the
module connectors into the con-
sole connector sockets.
Re-fit the fixing screws at either
end of the module panel.
Push