Allen&Heath GS1 USER GUIDE - Manual (Page 7)

1
2
C HANNEL A UX S ENDS
There are five Aux busses on the GS1. These are typically used for sending
channel signals to common FX such as reverbs and delays. Auxs 2-5 are always
post fade. Aux sends 4 & 5 are accessed by pressing the Channel Aux send select
switch.
M
ASTER A UX S ENDS
Aux 1 can be switched at the master section to be pre fade. A pre fade Aux is
commonly used for foldback or cue for a musicians headphone mix where the
monitor signal is not affected by channel fader. In most cases foldback will be
required from the tape returns, When Aux 1 is switched to pre, it selects the TAPE
RTN signal path from the mono channel strips.
A UX
10
2
GS1
N OTES
CHANNEL SENDS MASTER AUX SENDS
AUX (post)
CUE (pre)
1
2
3
4
5
Auxiliaries
0 10
0 10
0 10
0 10
0 10
0
0
1
LF -14 14
0 10
-14
Auxiliary Sends
0 10 0
3/5
0 10
to Aux 2 & 3
to Aux 4 & 5
2/4
1
2
9
S ECTION 2 S IGNAL P ATHS