Allen&Heath GS1 USER GUIDE - Manual (Page 5)

1
2
3
4
M ONO I NPUT
Main input gain control allows optimum settings of input signal. Set this level
using PFL and the Master Meters.
Use the Mic line switch to select the input source. When no input is connected to
the line socket this switch acts as a 30dB pad on the Mic input.
(See section 5)
The insert socket sends the input signal to an external device. This may be a gate,
compressor or de-esser. The signal returns to the same point in the channel path.
See the diagram in the connector section for correct wiring.
S TEREO I NPUT
If only the left input is used the signal appears on both left and right paths,
effectively mono.
M ONO I NPUT AND S TEREO I NPUT P ATHS
6
2
GS1
N OTES
STEREO INPUT
L
R
MONO INPUT - MIC AND LINE CONNECTED
4
GAIN
1
MIC/LINE XLR
2
3 1 2
GAIN
LINE
INSERT
3
LO
HI
0 10
5
S ECTION 2 S IGNAL P ATHS