Allen&Heath Scepter SERVICE MANUAL - Manual (Page 5)

Audio Owner Manual Section 5
Channel Aux Send Source Select
Three choices are available for each of the four Auxiliary Sends. Aux A B
are set up as Monitor or Cue sends (Pre-EQ/Pre-Fader); Aux C D are set as EFX
sends (Post-Fader). Normally all Aux sends are muted along with the channel, but
the Pre-EQ source can be set to ignore the Mute switch. (see Pre-Eq Mute/No
mute
section) The Pre-EQ can also be set to 1 of 3 different configurations (See Pre-EQ
Source Select).
1 Pre-EQ Aux Send signal follows Gain control only. Auxes A
B default factory setting. This source has 3 extra
configuration options. (see Pre-Eq Source Select)
2 Pre-Fader Aux Send follows the EQ and Mute switches; Fader
level has no effect. Same signal as PFL.
3 Post-Fader Aux Send follows Fader and Mute Switch. Used for
Effect send. Auxes C D default factory setting.
Pre-EQ Source Select
Three choices are provided for the Pre-EQ source. Normally the Post-Insert/
Post-HPF option is selected. The aux signal will be after any signal processing
equipment you may have patched into the Channel Insert jack and also the channel
High pass filtering. If you want the Aux send to be unaffected by the external
equipment, select the Pre-Insert option. Likewise, choose the
point if you want the Aux to have the effect but not have the High Pass Filtering.
1 Pre-Insert Pre-EQ point is directly after the channel preamp
section. Any external equipment will not affect the
aux send signal.
2 Post Pre-EQ point follows any external equipment but is
not affected by HPF switch.
3 Post Insert/Post HPF Pre-EQ signal is after any external processing
equipment and is affected by the HPF switch. This
is the factory default setting.
33