Aladdin Light Lift ALL200-CM-240V - Manual (Page 12)

ALL200 TROUBLESHOOTING GUIDE
TECH SUPPORT: (877) 287-4601 Monday through Friday 8:00am to 4:00pm US CST
I. Troubleshooting and installation must be performed by a licensed, bonded, and insured electrician.
Electricity can cause death, personal injury, and/or property damage.
II. To perform most troubleshooting procedures, the following tools will be needed:
a. 5/16” nut driver or 5/16” socket and ratchet
b. Volt Meter
c. 14 AWG jumper wire
III. Prior to troubleshooting or installation, read, understand and follow each safety warning in the ALL200
installation instructions and safety precautions supplement. Failure to follow Aladdin’s safety precautions
and/or warnings could cause the chandelier to fall, which could cause death, injury, and/or property damage.
SYMPTOM: ALL200 DOES NOT OPERATE:
Once ALL200 is installed per the installation instructions, use the following steps to troubleshoot.
1. Confirm motor switch in the square box is turned on. The square box is mounted on the chassis plate of
the ALL200, right in front of the control board. If it was found in the off position, flip it to the on position
and use the controller to test the ALL200. If ALL200 still does not operate, proceed to step 2.
2. Turn the motor and light switch in the square box to the off position. Using the 5/16” nut driver or
socket, remove dust cover. Confirm motor fuse is good. The motor fuse is held to the control board by fuse
clips and is located right in front of the motor assembly. Remove and perform a continuity test on the motor
fuse. If the fuse reads continuity, place it back in the fuse clips. If it does not read continuity, it must be
replaced with a good, 1.6 amp, slow blow fuse. Turn the motor and light switch in the square box to the on
position, and use controller to test the ALL200. If the ALL200 still does not operate, proceed to step 3.
3. Turn the motor and light switch in the square box to the off position. Confirm limit switch wires are
attached properly. Confirm the limit switch wires are properly connected to the limit switch as well as the
limit switch terminals on the control board. The limit switch is located on top of the ceiling box. The white
limit switch wire should be plugged from COM on the control board to the single terminal side of one
limit switch. The green limit switch wire should be plugged from NO on the control board to the top limit
switch terminal on the double terminal side of the limit switch. The red limit switch wire should be plugged
from NC on the control board to the bottom limit switch terminal on the double terminal side of the limit
switch. If limit wires were found plugged incorrectly, plug them to their corresponding terminal and use the
controller to test the ALL200. If the ALL200 still does not operate, proceed to step 4.
4. From where the ALL200 is installed, call Aladdin Light Lift technical support Monday through Friday
during normal business hours at (877) 287-4601.
SYMPTOM: CHANDELIER WILL NOT LIGHT:
Once the ALL200 is installed per the installation instructions, use the following steps to troubleshoot.
Note: If the top contact plate is painted, the chandelier will not light.