Aladdin Light Lift ALL200RM-CM - Manual (Page 12)

STEP 20
Loosely fasten chandelier pulley assembly to suitable structure using 7/16” x 4” hex tap bolts, 7/16” nylon
lock nuts and 3/8” USS flat washers. See Diagram L.
STEP 21
Adjust ceiling box elevation up or down to be flush with sheetrock. Use 3/32” Allen wrench on conduit
coupler to loosen bottom set screw. Conduit is telescopic. The ceiling box should not touch inside of ceiling
hole. Retighten bottom setscrew on conduit coupler and confirm top set screw is tight. See Diagram L.
Never attach or adjust the conduit assembly and chandelier pulley assembly improperly. This could
interfere with the automatic shutoff system and could cause the chandelier to fall, which could cause
death, personal injury, and/or property damage.
7/16” x 4” Hex Tap Bolt (QTY 4)
3/8” USS Flat Washers (QTY 8)
7/16” Nylon Lock Nuts (QTY 4)
Sheetrock Sheetrock
4 1/2” Hole
Diagram L
Conduit Coupler
Top Set Screw
3/32” Allen Wrench
Conduit Coupler
Bottom Set Screw
3/32” Allen Wrench