AirLive WN-5000PCI - Manual (Page 16)

WN-5000 PCI User’s Manual
13
2-2 Connect to Wireless Access Point
There are two ways you can configure your wireless network card to connect to wireless access point: using
the AirLive Wireless configuration utility which comes with wireless card driver, and using built-in windows
zero configuration utility.
2-2-1 Using AirLive Wireless Utility
Please follow the following instructions to use AirLive Wireless configuration utility to connect to wireless
access point.
1. Right-click the AirLive Wireless configuration utility icon located at lower-right corner of computer desktop,
then click ‘Launch Config Utilities’.
2. Configuration utility will scan for all wireless access points automatically. Scan results will be displayed
here, please check if the wireless access point with the SSID (the name of wireless access point) you
preferred is shown here.
If the wireless access point you wish to connect does not show here, please click ‘Rescan’ to try again,
until the one you preferred is displayed. You may have to click ‘Rescan’ for more than two times before
you can see the access point you wish to use here sometimes.
If you still can not see the access point you wish to use after clicking ‘Rescan’ for more than five times,
please move your computer closer to the location where the wireless access point is, or see instructions
in chapter 3-2 ‘Troubleshooting’.