AirLive Live-GSH5T - Manual (Page 25)

Appendix B Troubleshooting
19
Live-GSH5T Gigabit Ethernet Switch
Appendix B Troubleshooting
This appendix contains specific information to help you identify and solve problems.
If your switch does not function properly, please make sure it is set up according to
the instructions on the manual.
If you suspect your switch is not connected correctly to your network, check the
following points before you contact your local dealer for support.
• Make sure the Power is ON (Check the Power LED).
• Make sure the cable is connected properly on both ends.
• Make sure that the maximum cable length between switch and end node
does not exceed 100 meters (for 10/100/1000BASE-TX connection).
• Make sure that the maximum switch-to-hub/switch cable distance does not
exceed 100 meters (for 10/100/1000BASE-TX connection).
• Verify that the cabling type used is correct.
• Check the corresponding 10M/100M/1000M Link/ACT. If one of them do
not light up, that means a faulty connection. Check the status of the cable
attachment. If the problem persists, try a different cable.
• Try another port on the Switch.
• Turn off power supply to the Switch. After a while, turn it on again to see if
it resumes to its normal function.
• If you find out where the problem is but cannot solve it by yourself, or you
simply cannot locate what is at fault, please contact your local dealer for
technical support.