A2Z Ozone AQUA TOUCH - Manual (Page 3)

3
Installation Instructions:
Please refer to the above figures for installation
1. Select a location where temperature will not exceed 122 degrees Fahrenheit (50 degrees
Celsius and where the bottom of the unit will be 1 inches (2.5 cm) higher than the bottom
of the faucet. Fig.1
2. Obtain a screw with a head that fits up into the slotted mounting hole on back of unit,
and drill a hole in the wall for the screw. The bottom of the unit should be located 1 inch
(2.5 cm) higher than the bottom of the faucet. Fig.2
3. Hang the unit by slipping the slotted hole over the screw head. Fig.3
4. Ensure the screw is far enough to hold the unit flush, firmly and secure against the wall.
5 Connect one end of the white silicone tube to the ozone nipple on the bottom of the unit.
Fig.4
6. Remove the existing aerator from the faucet. Fig.5
7. Attach the unit’s chrome aerator to the faucet. The aerator has two sections to allow
attachment to internal or external threads. Connect the other end of the white silicone tube
to the nipple on the aerator. Fig.6
8. Secure the white silicone tube to the wall if desired, and tie it the faucet with the plastic
ties provided, so that the tube is secure and does not interfere with the use of the sink.
Fig.7
9. Plug the power adapter into an outlet, and connect the power cord to the port on the side
of the unit. Fig.8