A2Z Ozone AQUA-6 - Manual (Page 9)

9
AQUA-6 WATER TREATMENT
The AQUA-6 Purifier can be used to purify water in emergency storage, spas, bathtubs,
fountains, and wading pools. It can also be used to purify drinking water from well sources
or city water supplies, remove undesirable tastes, chemicals, odors and colors caused by
iron, copper, manganese, chlorine and organic chemicals such as pesticides, and herbicides.
Do not use water from a source that is questionable such as stagnant pool of water or the
like.
To treat water, place white or gray dispersion stone into the water container (4 inches
deep only) and leave the unit on the recommended amount of time shown in the table
below. When completed, turn off the AQUA-6 Purifier and allow twenty minutes for excess
ozone to dissipate from the water. Higher output ozone generators are available for well
water and holding tanks when used in conjunction with a particulate filter. Ozone removes
excess minerals including iron, manganese, and lead, as well as radon and sulfur gases.
NUMBER OF GALLONS SUGGESTED TREATMENT TIME
1 2 minutes
5 10 minutes
Time setting depends upon water quality. A glass of tap water requires approximately 30
seconds (2 minutes per gallon).
SPA AND POOL TREATMENT
The AQUA-6 Purifier can be used on spas, hot tubs, and wading pools up to 1,000 gallons,
allowing you to reduce the chemical usage significantly. You will never need to put up with
dry skin, red eyes, faded suits, or green hair again! Ozone is pH neutral, so it will not
adversely affect the acid/alkaline balance of your water. It is more cost effective than
traditional chemicals and leaves no undesirable smell or taste. Continuous operation (10 to
20 minutes; function number 9 or 10) is proven to be the most economical treatment
method for spa water, fountains and larger bodies of water to 1,000 gallons.
1. The AQUA-6 Purifier must be sheltered from direct exposure from the elements
(rain and water). Place the unit at least five feet from the spa or water enclosure
and at least twelve inches above the maximum water level. Ensure that the
location is out of the reach of children or anyone in the water.
2. Connect the ozone supply tube to the ozone outlet vent at the bottom of the
purifier. If the ozone supply tubing is too long, trim it with household scissors or a
razor knife.
3. Place the white diffuser stone 4 inches into the body of water near the center for
maximum ozone saturation in the water.