A2Z Ozone AQUA-6 - Manual (Page 3)

3
Important Safety Information!!!!

This unit is not made for continuous operation. Do not run the unit without a 15
minute delay between run times.

Place ozonator higher than the water level. If water backs up into the unit it may
cause damage, which is not covered by the warranty and could cause electric
shock.

Place stone diffusers no more than 4 inches deep in the water and 2 inches
deep in oil.

After you turn off the function (push on/off under LCD), please wait for ten
seconds until the unit turns off automatically. Then unplug or turn the power off
(main power below the red light).
Read Before Use

Read the safety information above and instruction manual carefully before use.

Do not cover the air inlet on the back of the unit or the ozone vent on the bottom of
the unit. Improper ventilation may result in mechanical failure and will void the
warranty.

Store ozone generator in a cool, dry area.

Do not take apart the ozone generator. Mechanical failure may occur. Return unit
directly to manufacturer for repair.

Do not breathe in ozone directly.

Use ozone generator in an unoccupied room only.

Allow proper ventilation when entering a room after treatment.
Technical Specifications
Note: AQUA-6 comes in two different electric input configurations; one for 110/120VAC 50/60HZ and
the other for 220/240VAC 50/60HZ. Be sure to check the unit voltage input before plugging in the unit.
Technical Specifications
220/240 VAC 50 Hz/60 Hz
Power Input 220/240 VAC 50/60 Hz 10W
Ozone Output 600 mg/hour
Weight 0.865 kg
Dimensions 270 x 190 x 75 mm
Timer Settings See Timer Function Table