Echo PAS-225VPB - Manual (Page 28)

28 X7722275104
© 11/2013 ECHO Inc.
MAINTENANCE PAS-225VPB
Drive Shaft Upper
1. Loosen clamping knob (A).
2. Pull locator pin (B) and rotate 1/4 turn counter clockwise to
lockout position.
3. Remove attachment.
4. Remove coupler (E) from upper drive shaft assembly by
loosening clamping screw (C) and removing set screw (D).
5. Remove upper flex cable (F), wipe clean, and apply a thin
coating of 1/2 oz. (15ml) of grease.
6. Install cable. Make sure that the flex cable fully engages into
the clutch square drive socket.
7. Slide coupler on upper drive shaft until fully seated, and
align set screw hole in coupling with hole in upper drive
shaft.
8. Install and tighten set screw (D), and tighten clamping screw
(C).
Nylon Line Head Disassembly Instructions
Note: For normal use, Speed Feed © head disassembly is not
necessary. However, if circumstances require
disassembly, follow these instructions.
1. Press top of locking tabs (A) on both sides of Speed Feed ©
head to release cover (B) from eyelet carrier(C).
2. Remove cover from eyelet carrier.
A
C
D
B
A
E
D
B
F
A
B
C