Starting warm engine, Stopping engine, Starting warm engine stopping engine – Echo PAS-225VPB User Manual

Page 21: Pas-225vpb operation

PAS-225VPB

OPERATION

X7722275104

Starting Warm Engine

The starting procedure is the same as Cold Start except DO
NOT close the choke, and do not hold throttle trigger fully
depressed.

The attachment should not move at idle, otherwise serious
personal injury may result.

Note: If attachment moves, readjust carburetor according to

“Carburetor Adjustment” instructions in this manual or
see your ECHO Dealer.

1. Stop Switch

Move stop switch button (A) forward away from the STOP
position.

2. Purge Bulb

Pump purge bulb (C) until fuel is visible in the “Clear” fuel
return line. Pump bulb an additional 4 or 5 times.

3. Recoil Starter

Lay the unit on a flat area and keep movable attachment parts
clear of all obstacles. Firmly grip throttle handle and throttle
trigger lockout with left hand. Rapidly pull recoil starter
handle/rope (D) until engine fires.

Note: If engine does not start after 5 pulls, use Cold Start

Procedure.

Stopping Engine

1. Throttle

Release throttle trigger and allow engine to return to idle
before shutting off engine.

2. Stop Switch

Move stop switch button (A) backward to STOP position.

If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall
engine. Have your ECHO dealer repair stop switch before using unit again.