beautypg.com

Read the manuals, Clear the work area, Keep a firm grip – Echo 99944200620 User Manual

Page 8: Keep a solid stance, Avoid hot surfaces, Equipment

background image

8

X7532093905

© 10/2013 ECHO Inc.

SAFETY

99944200620

Read the Manuals

• Provide all users of this equipment with the Operator’s Manual

and Safety Manual for instructions on Safe Operation.

Clear the Work Area

• Spectators and fellow workers must be warned, and children

and animals prevented from coming nearer than 15 m (50 ft.)
while the unit is in use.

Keep a Firm Grip

• Always hold throttle handle and support handle with thumbs

and fingers tightly encircling the handles.

Keep a Solid Stance

• Maintain footing and balance at all times. Do not stand on

slippery, uneven or unstable surfaces. Do not work in odd
positions or on ladders. Do not over reach.

Avoid Hot Surfaces

• During operation, the drive shaft housing and attachment

bearing housing may become very hot, too hot to touch. Avoid
contact during and immediately after operation.

Equipment

Use this attachment with ECHO approved models only. Serious injury may result from the use of this
attachment combined with a non approved ECHO product.

• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.

• Inspect ProPaddle sweeper drums for damage and that they are firmly secured in place. Replace paddles

if damaged or worn excessively.

• Check that the ProPaddle attachment is firmly attached and in safe operating condition.

Note: ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories

which have not been tested and approved by ECHO.

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings.

ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete
stop before removing obstructions, clearing debris, or servicing unit.

DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.

NEVER reach into any opening while the engine is running. Moving parts may not be visible through
openings.