Echo EA-410 - Manual (Page 22)

22 X7504220703
© 10/2013 ECHO Inc.
MAINTENANCE EA-410
Air Filter
Level 1.
1. Brush dirt off air cleaner area. Keep dirt away from engine
and air intake grid.
2. Remove air filter cover. Brush dirt from inside cover and
away from edges of air filter.
3. Check air filter seal for tight fit with air filter case.
4. Remove air filter from case. Use care to prevent dirt and debris from falling into air filter case.
5. Inspect filter element and seal. Replace filter if any of these problems are present:
• Air filter seal does not fit tightly against case.
• Air filter seal is distorted, worn, or damaged.
• Air filter element has holes or other damage.
• Air filter element is saturated with dirt.
• Air filter element is soaked with fuel mix.
6. If air filter is in good condition and can be cleaned and reused, lightly brush debris from air filter element,
or blow filter element clean using low pressure (40 psi or less) compressed air directed at inside of filter.
When using compressed air, always direct air stream at inside surface of filter so dust and debris will be blown
out of filter. Keep air nozzle 6 - 8 inches away from filter to prevent damage to filter.
7. Install air filter in case, and replace cover.
Actual replacement interval for air filter depends on operating conditions. Operation in dustier applications
requires more frequent cleaning and replacement. Continued operation with a damaged or excessively dirty
filter will allow dirt and debris to enter engine, and result in poor performance, rapid engine wear, and premature
engine failure.
Fuel Filter
Level 1.
Fuel is VERY flammable. Use extreme care when mixing,
storing or handling, or serious personal injury may result.
1. Use a clean rag to remove loose dirt from around fuel cap
and empty fuel tank.
2. Use a hook to pull the fuel line and filter from the tank.
Parts Required: REPOWER TM Tune-Up Kit.
Parts Required: REPOWER TM Tune-Up Kit.