Echo CH450H Owners Manual v.1 - Manual (Page 8)

4 4.5 INCH HYDRAULIC CHIPPER
Section
assemBly
2
warninG
if any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
1. Move the chipper deflector weldment located inside the
chipper housing to the down position (Figure 2.1).
2. Slide the discharge cap onto the chipper housing,
ensuring that the weldment bolts fit in the notches on
the disk cover (Figure 2.2). install two (2) 5/16" serrated
flange nuts on the weldment bolts.
3. insert two (2) 3/8" x 5-1/2" bolts into the bolt holes on
the chipper housing and tighten using 3/8" washers
and 3/8" nylock nuts.
Figure 2.2, Discharge cap
Figure 2.1, Chipper deflector weldment
2.1 discharGe assemBly
1. attach the chipper chute to the chipper using four (4)
3/8" x 1" carriage bolts, 3/8" washers and 3/8" nuts. use
two bolts on each side. install with nuts on the outside.
2. attach the chute extension to the chipper chute using
three (3) 3/8" x 1" carriage bolts, 3/8" washers and 3/8"
nuts. install with nuts on the outside.
3. use the lanyard to attach the chute extension to the
middle hole on the chipper chute.
4. attach chute flap and flap strip to the chipper chute
as shown below with the three (3) 5/16 x 1" carriage
bolts, 5/16" washers, and 5/16" nylock nuts.
5. latch the chute extension to the lock plate on the
chipper chute.
2.2 chute assemBly
Figure 2.3, Chipper chute extension
CHIPPER
CHUTE
FLAP STRIP
CHUTE EXTENSION
LATCH
LOCK PLATE
CHUTE FLAP
ATTACH
LANYARD
HERE