Echo CH45342 Owners Manual v.2 - Manual (Page 10)

4.5 INCH CHIPPER 6
Section
attach both axles to the hitch pole using two 5/16" 1.
u-bolts, washers and locknuts.
Slide a wheel onto the axle and secure with a 5/8" 2.
washer and cotter pin. Repeat for the remaining
wheel.
Position the trailer onto the axle using a hoist or jack.
3.
Choose one of the following configurations:
Standard Configuration (Figures 2.1 & 2.2): a. the
axle and wheels should be positioned at the end
farthest away from the engine. Secure the trailer
to the hitch pole using two 3/8" x 1" carriage bolts,
3/8" washers and 3/8" nuts. the axle mounting
brackets located on each side of the trailer are
already mounted in the correct spot. attach the
axles to the axle brackets using two 5/16" u-bolts,
washers and locknuts.
optional Configuration (Figure 2.3):
b. Move the
axle mounting brackets on the side of the trailer to
the holes closest to the engine. attach the trailer
to the hitch pole using two 3/8" x 1" carriage bolts,
3/8" washers and 3/8" nuts. attach the axles to the
axle brackets using two 5/16" u-bolts, washers
and locknuts.
attach the hitch pole plate to the front of the hitch 4.
pole using two 3/8" x 1" bolts, 3/8" washers and 3/8"
nuts.
2
aSSEmbLY
Figure 2.1, standard trailer/hitch assembly
Figure 2.2, standard trailer configuration
Figure 2.3, optional trailer configuration (shown here with
optional Discharge tube Kit, PN 74634-00)
NoTE
The wheel base is adjustable from 36" to 46".
2.1 modEL CH45342 TRaILER aSSEmbLY
NoTE
The optional trailer configuration can be used with the
discharge Tube kit (PN 74634-00) to discharge materials
into a pickup bed. use the standard configuration to
discharge materials directly onto the ground.