Echo CH6614 Owners Manual v.1 - Manual (Page 19)

6 INCH CHIPPER 17
Section
elecTronic feed sensor
oPTional KiT for hYdraulic feeds
5
5.1 insTalling The sensor
Remove the drive belt guard.
On the collar located on the rotor shaft behind the chip-
per drive pulley, replace the set screw with the 5/16"
x 1-1/2" bolt included in the kit.
using the existing bearing bolt, attach the sensor and
bracket under an upper bearing bolt so that it lines up
with the 5/16" x 1-1/2" bolt from Step 2.
Remove outer and inner plugs from the relief valve and
install the solenoid cartridge valve and coil..
Connect the solenoid valve and harness to the lOFa
control and attach the ground wires to the frame. Route
positive lead near the hitch.
Replace the drive belt guard.
Connect the positive lead to a +12 volt DC power
source.
Mount lOFa control and route wires according to
Figure 5.1.1.
Program the system using the instructions included
with the feed kit and operate the chipper per manual
instructions.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Figure 5.1.2, Relief valve before installing the coil and valve
Figure 5.1.3, Relief valve after installing the coil and valve
noTe
For more detailed instructions on the feed kit, including
information on how to program the lOFa control, refer
to the instructions included with the kit.
Figure 5.1.1, Installing the electronic feed sensor