Echo CH6614 Owners Manual v.1 - Manual (Page 13)

6 INCH CHIPPER 11
ASSEMBLY
2.4 insTall The baTTerY
Check battery condition. Charge if needed.
Install 12 volt battery. Connect the positive cable to
the positive battery terminal and the negative cable to
the negative one.
1.
2.
2.5 add fluids
2.5.1 moTor oil
The machine was shipped with oil in the engine, as it
was tested at the factory.
To determine which type of oil to use, refer to the engine
owners manual included with the chipper.
Remove the oil dipstick and check oil level.
If necessary, fill with approved motor oil until the dip-
stick shows a correct oil level.
2.5.2 gasoline
With the engine stopped, make sure all moving parts
are stopped, disconnect spark plug from wire, and re-
move the key from the key switch. Only add gasoline
to a cool engine.
Clean area around fuel fill cap and remove the cap.
use a clean funnel to fill the fuel tank to 1/2" below bot-
tom of filler neck to provide space for fuel expansion.
Install fuel fill cap securely and wipe up any spilled
gasoline.
2.5.3 hYdraulic fluid
Hydraulic fluid drives the feed roller. The hydraulic pump
requires premium hydraulic fluids containing high qual-
ity rust, oxidation, and foam inhibitors. These include
premium turbine oils, aPI CD engine oils per SaE J183,
M2C33F or G automatic transmission fluids meeting Alli-
son C-3 or Caterpillar TO-2, and certain specialty agricul-
tural tractor fluids. For more information on the hydraulic
feed kit, see Section 4.
1.
2.
3.
4.
1.
2.
3.
imPorTanT
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.