Echo 76824 Instruction - Manual (Page 3)

Instruction Sheet
CONNECTING THE WIRES—RESET AND SAFETY CONTROLS
1. Under the Hydraulic Feed Housing, there is a portion of a wire harness that is shrink-wrapped. Carefully remove the
shrink-wrap. Remove the jumper harness plug (see drawing below).
2. Locate the weather proof connectors on the wire harness attached to the new tray (see Figure 1). The wires are red/
black for the Reset Control and red/light green for the Safety Control.
Figure 1 - Weather proof connectors
3. Match the colored wires from the harness on the new tray to the colored wires under the Hydraulic Feed Housing
and connect the connectors making sure they are locked.
JUMPER HARNESS PLUG