Echo 76824 Instruction - Manual (Page 2)

Instruction Sheet
CONNECTING THE WIRES
1. The wire harness comes assembled to the new tray. Find the red/black and red wires coming from this wire harness.
Connect these wires to the back of the Momentary Push Button Switch.
2. To attach the Momentary Push Button Switch to the Switch Box, start by knocking out the knock-out plug on the
Switch Box. The Switch Box is located on the hopper.
SMALL SCREW
TAKE OFF THIS NUT WHEN PUTTING THE
SWITCH ON THE CONTROL BOX
PUSH BUTTON
3. Take apart the Momentary Push Button Switch before installing it in the knock-out plug opening. To take the switch
apart, loosen the small screw that holds the silver-colored button to the Push Button Switch base (gold colored).
INSTALL CONTROL BOX MOUNT
SUPPLIED WITH KIT IN TOP SET
OF SLOTS
KNOCK-OUT PLUG
WHERE THE MOMENTARY
PUSH BUTTON SWITCH WILL
GO ON THE SWITCH BOX
4. Position the button and the base in the cutout on the Switch Box. One nut will be placed on either side of the black
box. After you have positioned the button and the base, make sure the pieces are tightened with the small screw.