Echo CH8670H Owners Manual v.2 - Manual (Page 11)

7 TURNTABLE CHIPPER
ENGLIS
h
ASSEMBLY
2.8 chIppER chuTE
Mount the chipper chute to the chipper housing using
eight 3/8" x 1" bolts and locknuts. use three bolts on each
side and two on the bottom (Figure 2.1).
To insert the top bolts, rotate the feed roller until the
notches (one on each side) on the feed roller are aligned
with the top bolt holes.
do not operate this unit without the chipper chute
correctly installed. Rotating cutting blades can cause
serious personal injury.
WaRNING
Figure 2.1 - Chipper Chute Assembly
HYDRAULIC
FEED
CHIPPER
CHUTE
2.9 chuTE EXTENSIoN TRaY
The Chute Extension Tray is an optional item and
purchased separately for domestic models.
The Chute Extension Tray is standard on S & F models.
After mounting the chipper chute to the chipper 1.
housing, slide the chute extension tray over the chipper
chute as shown in Figure 2.2.
Figure 2.2 - Chute Extension Tray Assembly.
hairpin Clip
Feed Control
lever
Chipper
Chute
Extension
hinge
Extension
Tray
Position this lip
behind the lip
on the chipper
chute shown
below. hold
the extension
tray directly
above the
chipper chute
and slide it
downward.
Make sure that you position the lip on the extension
tray behind the lip on the chipper chute. This provides
a flatter surface and prevents obstructions while feed-
ing the machine.
NoTE
2.7 coNNEcT ThE baTTERY
you will need to purchase a battery. Choose a battery
that meets or exceeds the engine manufacturer’s
specifications. Consult your engine owner’s manual or
authorized dealer for specification details.
To install the battery:
Open the battery box and insert battery into the battery 1.
box.
Attach the positive (red) battery cable from the engine
2.
to the positive (+) battery terminal.
Attach the negative (black) battery cable from the
3.
engine to the negative (-) battery terminal.
Secure the cover on the battery box with the strap.
WaRNING
To avoid sparks and a possible explosion or fire due
to a short circuit, do not touch the positive (+) battery
terminal and any surrounding metal with tools, jewelry
or other metal objects. When installing battery cables,
connect the positive (+) cable first and the negative (-)
cable last.
Align the five bolt holes in the chute extension tray with 2.
the bolt holes in the extension hinge.
Insert a 3/8" x 1" carriage bolt (included in owner's
3.
kit) through the two outside holes on the extension
tray and the extension hinge. Secure the bolts with
washers and nuts.
Insert one 3/8" x 1" carriage bolt through the end of the
4.
chute support and middle holes on the extension hinge
and extension tray. Secure the bolts with washer and
nuts. secure with hairpin clips.