Echo CH8670H Owners Manual v.4 - Manual (Page 26)

22 8 INCH TURNTABLE CHIPPER
SERVICE & MAINTENANCE
BEFORE INSPECTINg OR SERVICINg ANy PART OF THIS MACHINE, SHuT OFF POWER SOuRCE,
DISENgAgE THE HyDRAulICS, OPEN SHIElD AND MAkE SuRE All MOVINg PARTS HAVE COME TO A COMPlETE STOP.
WaRNING
WaRNING
Polyurea and lithium-based greases are not compatible.
Mixing the two grease types may lead to premature
failure.
NoTE
Do not over grease bearings. Overfilling can lead to
excessive heat and/or unseating of the seals. Add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
5.15 LubRIcaTIoN
lubricate the machine periodically with a lithium-based
grease. Extreme working conditions will require more
frequent greasing.
grease the following points every 50-100 hours of
operating time:
50 h
50 h
50 h
5.14 chaNGE oIL
Check the oil level before each use. Change oil as directed
in the engine owner's manual. The controller will blink a
code every 100 hours as a reminder to change oil. To reset
the controller, see Sec. 7.3.
Change the hydraulic oil filter after the first 50 hours of
operation and every 200 hours thereafter.
To change the hydraulic oil filter:
using an oil filter wrench, turn the filter 1.
counterclockwise.
Once the filter becomes loose, turn it out the rest of
2.
the way with your hand.
Properly discard old filter.
3.
lube the rubber seal on the new filter (PN 16922) with 4.
clean hydraulic oil.
Install the filter onto the threaded pipe. Turn with your
5.
hand until the filter is finger tight.
using an oil filter wrench, tighten the filter another ½
6.
turn.
Check hydraulic oil level and fill if necessary.
7.
5.13 chaNGE hYdRauLIc oIL FILTER