Echo CH8670H Owners Manual v.4 - Manual (Page 10)

6 8 INCH TURNTABLE CHIPPER
aSSEmbLY
Mount tires and rims to the axle using the lug nuts. 1.
Attach the fender supports to the trailer using three 2.
1/2" x 3-1/2" hex bolts, washers & nuts.
Attach the fenders to the fender supports using four
3.
3/8" x 1" carriage bolts, washers and nuts.
EuRopEaN modELS:
thread the wire harness through the hitch tube and 1.
slide the hitch tube into the trailer frame. Secure using
two 1/2" x 4-1/2" bolts, washers and nuts (provided in
owner's kit).
Slide the hitch coupler onto the hitch tube from the top
2.
and secure using 1/2" bolts, nuts and washers.
thread the wire harness through the metal loop on the
3.
underside of the coupler.
2.3 REaR STabILIzER
Verify that the rear stabilizer is installed. To install the
rear stabilizer, slide the stabilizer into the corresponding
bracket beneath the rear of the chipper frame. Adjust the
stabilizer and secure with the provided snap pin.
NoN EuRo modELS:
thread the wire harness through the hitch tube and slide
the hitch into the trailer frame. Secure using two 1/2" x
4-1/2" bolts, washers and nuts (provided in owner's kit).
Section
2
2.4 aTTach chIppER chuTE
Mount the chipper chute to the chipper housing using 1.
eight 3/8" x 1" bolts and locknuts. use three bolts on
each side and two on the bottom (Figure 2.2).
To insert the top bolts, rotate the feed roller until the
2.
notches (one on each side) on the feed roller are
aligned with the top bolt holes.
Connect the three wires coming from the feed chute
3.
to the connectors that are located underneath the
feed roller.
do not operate this unit without the chipper chute
correctly installed. Rotating cutting blades can cause
serious personal injury.
WaRNING
Figure 2.2 - Chipper chute assembly
WaRNING
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
CHIPPER
CHUTE
HYDRAULIC
FEED
2.1 TIRES aNd RImS
2.2 TRaILER hITch
REAR STABILIZER
SNAP PIN
Figure 2.1