Echo CH8993H Owners Manual v.7 - Manual (Page 11)

7 8 INCH TURNTABLE CHIPPER
ENGLISH
ASSEMBLY
2.3 REAR STABILIZER
Verify that the rear stabilizer is installed. To install the
rear stabilizer, slide the stabilizer into the corresponding
bracket beneath the rear of the chipper frame. Adjust the
stabilizer and secure with the provided snap pin.
2.4 ATTACH CHIPPER CHUTE
1. Mount the chipper chute (1) to the chipper housing
(2) using eight 3/8 x 1" bolts (3), washers (5) and
locknuts (4). Use three bolts on each side and two on
the bottom (Figure 2.5).
2. To insert the top bolts, rotate the feed roller until the
notches (one on each side) on the feed roller are
aligned with the top bolt holes.
3. Connect the three wires coming from the feed chute to
the connectors that are located underneath the feed
roller.
Do not operate this unit without the chipper chute
correctly installed. Rotating cutting blades can cause
serious personal injury.
WARNING
Figure 2.5, Attaching chipper chute
1
4
5
2
3
2.5 ATTACH CHUTE EXTENSION TRAY
1. Tilt the extension tray (1) up, so the bottom of the tray
is facing outward (Figure 2.6). Slide the extension tray
lips between the extension hinge and chipper chute
lips (2).
2. Tilt the extension tray down until the tray rests on the
extension hinge, and the extension tray lips contact the
back of the chipper chute lips.
3. Insert five 3/8 x 1" carriage bolts (3) (included in owner's
kit) through the extension tray and hinge. Secure the
bolts with washers (4) and nylock nuts (5) from the
bottom.
4. Attach the chute support weldment to the middle hole
of the chipper chute by using the existing bolt.
1 2
3
4
5
Figure 2.6, Attaching the extension tray
Make sure that you position the lip on the extension
tray behind the lip on the chipper chute. This provides
a flatter surface and prevents obstructions while feed-
ing the machine.
NOTE
REAR STABILIZER
SNAP PIN
Figure 2.4, Rear stabilizer