Echo CH9540H Instruction v.1 User Manual
Instructions, Warning, Mounting the lofa control
Instruction Sheet
Instructions
PRODUCT: ElEctronic FEEd
Kit (Pn 74898-00)
FITS MODEL: cH9540H (72854)
SERIaL nUMbER 803703 & bELOw
Pn 74916-00
rev. 010508
MOUnTIng ThE LOFa COnTROL
remove the drive shaft joint shield ring.
1.
remove upper belt guard.
2.
remove the top cover from the Feed roller Support
3.
unit. if the serial number is equal to or greater than
X01249, skip to StEP 7 (Figure 1).
remove the back cover from the loFA control, center it
4.
3-1/2” from the top on the front plate of the Feed roller
Support housing and mark the position of the holes.
drill four 1/4” holes (Figure 1).
5.
Attach the iSo-Mounts to the controller back plate with
6.
the bolts and nuts provided (Figure 2).
Secure the back plate of the controller to the Feed
7.
roller Support housing with a washer and one M4-
0.7 nut per bolt. Apply thread locking adhesive and
tighten.
replace the Feed roller Support cover.
8.
Attach the loFA control to the back plate (Figure 2)
9.
.
Figure 2
Figure 1
TOP COVER
FOUR 1/4" hOLES
waRnIng
BEForE inSPEcting or SErvicing Any PArt
oF tHiS MAcHinE, SHut oFF PowEr SourcE,
diSconnEct SPArK Plug wirE FroM SPArK
Plug And MAKE SurE All Moving PArtS HAvE
coME to A coMPlEtE StoP.