Echo CH9540H Instruction v.3 - Manual

Instruction Sheet
Instructions
PN 76220-00
Rev. 080608
SUBJECT: PTO 3-POINT BRACE
KIT # 76086-00
FITS MODELS: CH9540H,
CHF9540H
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect the
battery cables and make sure all moving parts have
come to a complete stop.
WARNING
These instructions will describe how to: Install the 3-point
hitch brace kit.
REMOvE BELT GUARDS
Remove the Upper PTO belt guard from the chipper 1.
by removing the eight bolts.
CUT UppER BELT GUARD
1. Cut a rectangular hole into the Upper PTO Belt Guard
following the measurements provided in Figure 2.
11.69"
16.55"
1.5” IN WIDTH
2. From the outside edge, measure in 11.69" to make
the outside edge cut.
3. The cut needs to be 16.55" in height and 1.5" in
width.
If you do not want to cut your shields, you can purchase
pre-cut shields separately by contacting your dealer.
Note