beautypg.com

Spark plug, Cooling system, Cleaning grill and cylinder fins – Echo PB-265LN User Manual

Page 20: Spark plug cooling system, Maintenance pb-265ln spark plug

background image

20

X7501183702

© 03/2013 ECHO Inc.

MAINTENANCE

PB-265LN

Spark Plug

Level 2.

Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada)
otherwise severe engine damage may occur.

1. Remove spark plug and check for fouling, worn and rounded

center electrode.

2. Clean the plug or replace with a new one. DO NOT sand blast to clean. Remaining sand will damage

engine.

3. Adjust spark plug gap by bending outer electrode.
4. Tighten spark plug to 150-170 kgf • cm (130-150 in • lbf).

Cooling System

Level 2.

To maintain proper engine operating temperatures, cooling air must pass freely through the cylinder fin area.
This flow of air carries combustion heat away from the engine.

Overheating and engine seizure can occur when:

• Air intakes are blocked, preventing cooling air from

reaching the cylinder.

• Dust and grass build up on the outside of the cylinder. This

build up insulates the engine and prevents the heat from
leaving.

Removal of cooling passage blockages or cleaning of cooling
fins is considered “Normal Maintenance.” Any failure
attributed to lack of maintenance is not warranted.

Cleaning Grill and Cylinder Fins

1. Remove accumulated debris from intake grill between

backpack frame and blower housing.

2. Disconnect spark plug lead from spark plug.
3. Remove spark plug.
4. Remove engine cover.
5. Loosely install spark plug to keep dirt out of cylinder.
6. Clean cylinder fins to allow cooling air to pass freely.
7. Reassemble parts in reverse order.

Parts Required:

REPOWER

TM

Tune-Up Kit

Parts Required:

None if you are careful.

Intake Grill