BURY CL 1010 Time - Manual (Page 9)

9
5. Establishing the power supply
The power supply of the system is established via a 3-core cable. Connect the black (clamp 31 – mi-
nus), the red (clamp 30 – steady plus) and the blue cable (clamp 15 – ignition plus) to the power sup-
ply of your radio (where required via the cigarette lighter or the fuse box).
Attention:
The blue cable must not be connected to clamp 30, otherwise it is not possible to start X
or finish a journey (ignition signal requirement). Also, if the vehicle is not running for a
long period, it could cause the car battery to run out.
6. Installation instructions for the fuses
Please cut through the red, the black and the blue cable by means of a
wire cutter or scissors. Now insert the two endings of the red cable
resulting from the cut into one of the binders, then close it. If you hear
two clicking noises, the clamp snapped in properly. Now insert one of
the fuses and then repeat the procedure with the other cables.