BURY CL 1010 Time - Manual (Page 6)

6
Installation of the system
After having found a suitable position in the vehicle you can mount /
attach the holder accordingly. Please use a cleaning cloth for degrea-
sing the surfaces you want to attach the holder to.
The end of the cable with the small Molex plug is ideally suited for pla-
cing through small openings in the dashboard area. This facilitates a
practically invisible installation of the cable. Take the length of the cable
into account and make sure that it is of sufficient length to reach the
intended location of the connector box.
Important:
When positioning the monitor please take care that the X
CL 1010 Time does not impair the view onto the road, that
it will not be installed in the impact zone of the passenger
compartment (amongst others in the airbag inflation zones)
and that cables may be laid without any problems.
The holder can be affixed just once, removing could da- X
mage the adhesive area. In case of high variations in tem-
peratures - depending on the structure and the features
- decolourisations of the surfaces can occur during the sub-
sequent utilization.