BEA LO Linx 80.0240.04 - Manual (Page 5)

SIZE: DRAWN BY:
TITLE: BESAM CUP/MP W/LO-LINX
B
NOTES:
1. MOTOR CONNECTION IS TIED IN PARALLEL TO EXISTING MOTOR LEADS. NO RESPECT TO POLERITY IS REQUIRED.
2. LEAVE THE FACTORY INSTALLED JUMPERS IN PLACE.
3. THE KNOWING ACT SWITCH IS CONNECTED AT THE AUX INPUT AND CAN BE ANY DRY CONTACT DEVICE SUCH AS A PUSHPLATE, CARD READER, ETC. THE AUX INPUT IS REQUIRED FOR ALL INITIAL ACTIVATION WHEN FUNCTION FA ON THE LO-LINX
IS SET TO '01'.
4. THE SECOND BODYGUARD AND EAGLE ARE PRIMARILY USED IN DUAL-EGRESS APPLICATIONS. IF A SECOND BODYGUARD IS REQUIRED, USE A "Y" HARNESS (20.5083).
5. SET CONTROL FUNTIONS WITH PMD 20 = A, 11 = DEGREE AT WHICH TO INHIBIT SUPERSCAN DEPENDING ON APPLICATION 65-75 DEGREES TYPICALY; 17 = 00; 18 = 00
REV BY:
TUC 80.0245.03
SCALE: DATE:
NONE 05/17/2007
PART NO:
SHEET
1 OF 1
IF AFTER TROUBLESHOOTING A PROBLEM, A SATISFACTORY SOLUTION CANNOT BE ACHIEVED, PLEASE CALL B.E.A., INC. FOR FURTHER ASSISTANCE DURING EASTERN STANDARD TIME @ 1-800-523-2462 FROM 8AM - 5PM. FOR AFTER-HOURS, CALL EAST COAST: 1-866-836-1863 OR 1-800-407-4545 / MID-WEST: 1-888-308-8843 /
WEST COAST:1-888-419-2564. DO NOT LEAVE ANY PROBLEM UNRESOLVED. IF YOU MUST WAIT FOR THE FOLLOWING WORKDAY TO CALL B.E.A., LEAVE THE DOOR INOPERABLE UNTIL SATISFACTORY REPAIRS CAN BE MADE. NEVER SACRIFICE THE SAFE OPERATION OF THE AUTOMATIC DOOR OR GATE FOR AN INCOMPLETE
SOLUTION.WEB: WWW.BEASENSORS.COM
Pre-wired
switch
assembly
LO-LINX
SETUP PWR TO CTRL BEAM
TX RX
SWITCH
AUX SENSORS MTR STALL
Patent Pending
EAGLE 1
24 V
TRANSFORMER
RED
RED
BODYGUARD 1
BLACK
RED
LO-LINX BODYGUARD
DUAL-EGRESS HARNESS
p/n: 20.5083
COM
N/O
LO-LINX SUPERSCAN HARNESS
p/n: 70.5071
EAGLE 2 BODYGUARD 2
LO-LINX SUPERSCAN HARNESS
p/n: 70.5071
MOTOR
-
+
BLACK
BLACK
RED
RED
DOOR MTD SENSOR
APPROACH SIDE
DOOR MTD SENSOR
SAFETY SIDE
DOOR MTD SENSOR
APPROACH SIDE
DOOR MTD SENSOR
SAFETY SIDE
SEE NOTE #4
CUP
SLAVE
CUP
MASTER
SYNC CABLE
BLUE
YELLOW
WHITE
GREEN
BROWN
SEE NOTE #1 SEE NOTE #2
SEE NOTE #5
SEE NOTE #3
LO-LINX MOTOR HARNESS
p/n: 70.5076
LO-LINX
BODYGUARD
HARNESS
p/n: 70.5082
LO-LINX EAGLE HARNESS p/n: 70.5096
LO-LINX POWER HARNESS p/n: 70.5095
LO-LINX HOLD SWITCH HARNESS p/n: 70.5078
LO-LINX CONTROL HARNESS p/n: 70.5097
HOLD OPEN
OFF
ON
RED
BLACK
WHITE
TUC
100 ENTERPRISE DRIVE
PITTSBURGH, PA 15275
PHONE: (412) 249-4100
FAX: (412) 249-4101
EMAIL: www.beasensors.com