JLG 80HX_HX+6_HXER Service Manual - Manual (Page 72)

SECTION 2 - PROCEDURES
2-50 – JLG Lift – 3120863
11. Place second set of sixteen needle rollers into clus-
ter gear.
12. Apply grease or petroleum jelly to tang side of two
thrust washers. Place thrust washers against bosses
in carrier with washer tang fitting into slot in carrier
outside diameter.
13. While keeping thrust washers in place, slide cluster
gear into carrier with larger gear on side with small
pin hole.
14. Line up cluster gear and thrust washers with hole in
carrier and slide planet shaft through. Ensure cham-
fered side of hole in planet shaft is lined up with pin
hole in carrier.
15. Drive anti-roll pin flush into carrier hole, locking
planet shaft into place.
16. Repeat steps 8 thru 15 for remaining two cluster
gears.