JLG 19BD Operator Manual - Manual (Page 13)

SECTION 1 - SAFETY PRECAUTIONS
3121153 – JLG Lift – 1-3
1.3 OPERATION
General
• Always ensure the machine is properly attached to a solid,
firm and level floor surface.
• Do not use the machine for any purpose other than posi-
tioning personnel, their tools and equipment.
• Never operate a machine that is not working properly. If a
malfunction occurs, shut down the machine.
• Do not allow personnel to tamper with or operate the
machine from the ground with personnel in the platform,
except in an emergency.
• Do not carry materials directly on platform railing unless
approved by JLG.
• Always ensure that power tools are properly stowed and
never left hanging by their cord from the platform work
area.
• Fully lower mast assembly and shut off all power before
leaving machine.
• When performing welding operations at elevation, precau-
tions must be taken to protect all machine components
from contact with weld splatter or molten metal.
• Never exceed the maximum platform capacity. Distribute
loads evenly in the platform.
• Never attempt to use the machine as a crane.
• Do not increase the platform size with unauthorized deck
extensions or attachments.
• If mast assembly or platform is caught while elevated, the
operator must be removed before attempting to free the
machine. Use cranes, forklift trucks, or other appropriate
equipment to stabilize machine prior to removing person-
nel.
Trip and Fall Hazards
• JLG Industries, Inc. recommends that the operator in the
platform use an approved fall restraint device with a lan-
yard attached to the authorized lanyard anchorage point.
For further information regarding fall protection require-
ments on JLG products, contact JLG Industries, Inc.