JLG 860SJ Parts Manual - Manual (Page 341)

3121140 800S 860SJ 7-9
SECTION 7 ELECTRICAL
218E 4460466 8 Seal, Plug
219 to 232 Not Used
233 4922660 1 Holding Valve/Lift Dump Harness Assembly
(Note: This is actually two separate harnesses under the
same p/n) 2/D
233A 4460880 2 Connector, DIN
233B 4460320 1 Plug, Male - 2 Position
4460226 2 Socket, Female
233C 4460424 1 Connector, Female - 2 Position
4460267 2 Pin, Male
234 Not Used
235 4922871 2 Harness, Limit Switch Upper (SN 0300071452 to
SN 0300085332)
1 To Boom Capacity Angle Switch
1060902 34ft/10.4m Cable, Electrical - 18/2
4460464 2 Pin, Male
4460897 1 Receptacle, Female - 2 Position
1 To Boom Transport Length Limit Switch
1060902 34ft/10.4m Cable, Electrical - 18/2
4460464 2 Pin, Male
4460897 1 Receptacle, Female - 2 Position
236 4922872 2 Harness, Limit Switch Lower (SN 0300071452 to
SN 0300085332)
AR To Boom Capacity Length Switch
1060902 20ft/6m Cable, Electrical - 18/2
4460465 2 Socket, Female
4460891 1 Plug, Male - 2 Position
AR To Boom Transport Length Limit Switch
1060902 20ft/6m Cable, Electrical - 18/2
4460465 2 Socket, Female
4460891 1 Plug, Male - 2 Position
237 AR Cable, Electrical - 18/2 (SN 0300071452 to
SN 0300085332)
1061018 2 800S
1061019 2 860SJ
238 1 Harness Options (To Bulkhead) (SN 0300071452 to
SN 0300085332):
4922873 Harness, 110V A/C - 800S (Standard)
4922790 Harness, 8/5 Cable - 800S (With 7500W Generator)
4922877 Harness, 110V A/C - 860SJ (Standard)
4922808 Harness, 8/5 Cable - 860SJ (With 7500W Generator)
239 1 Harness Options (To Generator Box) (SN 0300071452 to
SN 0300085332):
4922874 Harness, 110V A/C (Standard)
4922809 Harness, 8/5 Cable (With 7500W Generator)
FIGURE 7-2. HARNESS COMPONENTS INSTALLATION (WITHOUT UGM) (PRIOR TO SN
0300085332) (CONTINUED)
ITEM # PART NUMBER QTY. DESCRIPTION REV.