JLG 45e ANSI Service Manual User Manual
Models, Service & maintenance
This manual is related to the following products:
Table of contents
Document Outline
- Section A. INTRODUCTION - MAINTENANCE SAFETY PRECAUTIONS
- Section 1. SPECIFICATIONS
- Section 2. PROCEDURES
- 2.1 GENERAL.
- 2.2 SERVICING AND MAINTENANCE GUIDELINES.
- 2.3 LUBRICATION INFORMATION.
- 2.4 CYLINDERS - THEORY OF OPERATION.
- 2.5 VALVES - THEORY OF OPERATION.
- 2.6 MOTOR CONTROLLER.
- 2.7 WEAR PADS.
- 2.8 BOOM MAINTENANCE.
- 2.9 CYLINDER CHECKING PROCEDURES.
- 2.10 CYLINDER REPAIR.
- 2.11 CYLINDER REMOVAL AND INSTALLATION.
- 2.12 TILT INDICATOR SWITCH LEVELING PROCEDURE. (If Equipped.)
- 2.13 BOOM LIMIT SWITCHES.
- 2.14 POWER TRACK REMOVAL PROCEDURE (35/n35/40/n40/45 electric).
- 2.15 PRESSURE SETTING PROCEDURES. (In Sequence) (See Figure 2-29)
- 2.16 SWING BEARING.
- 2.17 DRIVE TORQUE HUB. (See Figure 2-34)
- 2.18 DRIVE BRAKE ASSEMBLY. (See Figure 2-35.)
- 2.19 MID AND LOWER LIFT CYLINDER BLEEDING PROCEDURE. (40/n40/45 electric)
- 2.20 BOOM SYNCHRONIZING PROCEDURE. (40/n40/45 electric)
- 2.21 FREE WHEELING PROCEDURE.
- 2.22 FOOTSWITCH ADJUSTMENT.
- 2.23 P/q controller.
- 2.24 AXLE DRAIN PLATES
- 2.25 PREVENTIVE MAINTENANCE AND INSPECTION SCHEDULE.
- Section 3. TROUBLESHOOTING