JLG 45e ANSI Service Manual - Manual (Page 35)

SECTION 2 - PROCEDURES
3120743 – JLG Lift – 2-11
2.7 WEAR PADS.
Main Boom. (Models 35/n35/40/n40/45)
1. Shim up wear pads until snug to adjacent surface.
2. Replace wear pads when worn to thickness shown
in Figure 2-2.
3. Adjust wear pads as follows:
a. a. Loosen jam nut on adjustment bolt, turn bolt
CW until wear pad is snug to adjacent surface.
b. b.After adjustments have been made, tighten the
jam nuts on wear pad bolts.
Figure 2-2. Location and Thickness of Wear Pads.