Section 1. specifications, 1 capacities, Hydraulic oil reservoir – JLG 19AMI Service Manual User Manual
Page 11: 2 component data, Hydraulic pump/electric motor assembly, Batteries - dc models, Battery charger - dc models, 3 performance data, Platform capacity (max. rated load), Machine speeds

SECTION 1 - SPECIFICATIONS
3121190
– JLG Lift –
1-1
SECTION 1. SPECIFICATIONS
1.1 CAPACITIES
Hydraulic Oil Reservoir
DC Models – 5 qts. U.S. (4.7 ltr.)
1.2 COMPONENT DATA
Hydraulic Pump/Electric Motor Assembly
DC Models - 12 Volt DC motor/pump
Motor - 12v - DC Standard Duty
Pump Displacement – .098 cu. in./rev.(AFC 1.6 cc/rev.)
Pump Output – 1.42 GPM @ 800 PSI @ 11.7v-DC @
135 AMPS @ 45 Centistrokes (200
SSU)
Pressure Relief – Adjustable Range 1500 to 3500 PSI,
Set to 2800 PSI (193 bar) at fac-
tory
Batteries – DC Models
WET (Standard)
12 Volt - 165 Amp (min.) - Deep Cycle Marine - RV -
80 lbs.
DRY (Option)
12 Volt – 165 Amp (min.) – Deep Cycle Marine - RV -
80 lbs.
AGM (Absorption Gas Mat) (Option)
12Volt – 100 O.A.H. – M2 Marine Combination -
104 lbs.
Battery Charger – DC Models
110/240 Volts AC, 50/60 Hz - input
12 Volt DC, 10 Amp - output
Automatic SCR Charger
Selectable Voltage
NOTE: A high output - 12Volt DC, 20 Amp output - SCR
charger is supplied with the AGM battery option.
1.3 PERFORMANCE DATA
Platform Capacity (max. rated load)
19AMI - 350 lb.* (160kg) - ANSI-U.S.A./Latin America
* Evenly distributed on platform floor.
Machine Speeds
19AMI - Lift up - 34 seconds *
Lift down - 18 to 25 seconds *
*Timed with maximum rated load: 350 lb. (160kg)
Machine Weight
(w ith S tan dard Platfo rm )
19AMI - 1,130 lbs. (513 kg)
Machine Height
(Platfo rm S tow ed)
19AMI - 78 in. (1.98 m)
Maximum Platform Height
(Mas t F u lly E x ten ded)
19AMI - 19 ft. 1 in. (5.8m)
Maximum Working Height
(A v erag e pers o n )
19AMI - 25 ft. (7.62m)
Machine Overall Width and Length (
B
as e)
19AMI - 34 in.(W) x 55 in.(L)
(86.3 cm x 139.7 cm)
1.4 TORQUE REQUIREMENTS
When maintenance becomes necessary or a fastener has
loosened, refer to the Torque Chart, Figure 1-2. to deter-
mine proper torque value per fastener size and thread
type.