JLG 20VP (3120848) Operator Manual - Manual (Page 38)

SECTION 5 - OPTIONAL EQUIPMENT
5-2 – JLG Lift – 3120848
5.2 EXTENDIBLE PLATFORM OPERATION
PLEASE NOTE THAT THE OPTIONAL EXTENDIBLE PLATFORM IS
ONLY AVAILABLE FOR THE 20VP AND CAN ONLY BE MOUNTED
ON THAT MODEL.
The optional extendible platform is designed to increase
operator reach over the front of the machine, this allows
the operator access to work areas which may otherwise
be unreachable from the standard platform. The following
procedures describe proper use of the Extendible Plat-
form.
Mounting to Mast
The Extendible Platform uses the same quick-mount hard-
ware as the standard platform, see Section 4-4. “Quick-
Change Platform” in the Operators and Safety manual for
procedures to mount and remove the platform on the
mast.
Once the platform is mounted re-check that all mounting
pins on upper and lower platform mast mounts, two (2)
pins on upper mount and two (2) pins on lower mount are
installed and secure.
Entering/Exiting Platform
(Refer to Figure 5-1.)
The Extendible Platform is equpped with a swing-up gull-
wing gate for entrance into the platform.
THE TOTAL WEIGHT CAPACITY FOR THE EXTENDIBLE PLAT-
FORM ASSEMBLY IS 160/120KG (350 LB./265 LB.) – CE SPEC.
WITH A MAXIMUM OF 120KG (265 LB.) ALLOWED ON PLATFORM
EXTENSION.
1. To enter the platform, raise the swing up gate by
grasping the front mid rail with one hand and pulling
up on the gate release handle on the front of the
platform assembly.
2. Next lift the gate high enough to enter the platform.
Step into the platform, when completely inside plat-
form, lower the gate until it’s closed and the gate
latch is engaged and latched.
3. To exit platform, repeat the above steps and exit the
platform.
Figure 5-1. Extendible Platform. (Platform shown extended)
HANDLE
SPRING
CLAMP
PLATFORM
EXTEND
HANDLE
GATE
RELEASE
HANDLE
PLATFORM EXTEND HANDLE
(Shown both locked in handle
spring clamp and raised for
extending platform)
EXTENDED
RETRACTED