JLG 450A_AJ Series II Operator Manual - Manual (Page 51)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121289 – JLG Lift – 3-15
3. Tilt Alarm Warning Light and Alarm
This illuminator indicates that the chassis is on
a slope. An alarm will also sound when the
chassis is on a severe slope and the boom is
above horizontal. If lit when boom is raised or
extended, retract and lower to below horizon-
tal then reposition machine so that it is level before continu-
ing operation. If the boom is above horizontal and the
machine is on a severe slope, the tilt alarm warning light will
illuminate and an alarm will sound and CREEP is automati-
cally activated.
IF TILT WARNING LIGHT IS ILLUMINATED WHEN BOOM IS RAISED OR EXTENDED, RETRACT
AND LOWER TO BELOW HORIZONTAL THEN REPOSITION MACHINE SO THAT IT IS LEVEL
BEFORE EXTENDING BOOM OR RAISING BOOM ABOVE HORIZONTAL.
4. Glow Plug/Wait to Start Indicator
Indicates the glow plugs are operating. After
turning on ignition, wait until light goes out
before starting engine.
Tilt Angle Market
3° CE & Australia
5° ANSI, CSA & Japan