JLG 510AJ Operator Manual User Manual
Page 108
SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6-26
– JLG Lift –
3121179
2. A. Swing Bearing - Teeth
(Prior to S/N 0300069337)
Lube Point(s) - Spray On
Capacity - A/R
Lube - OGL
Interval - Every 3 months or 150 hrs of operation
Comments - More frequent lubrication intervals may be
required
B. End Bearings - Worm Gear*
(Prior to S/N 0300069337)
Lube Point(s) - 2 Grease Fittings
Capacity - A/R
Lube - MPG
Interval - Every 2 years or 1200 hrs of operation
Comments - Remove grease fittings and install plugs
after greasing
*If necessary install grease fittings into worm gear hous-
ing and grease bearings.
DO NOT OVERGREASE END BEARINGS. OVERGREASING BEARINGS
WILL RESULT IN BLOWING OUTER SEAL IN HOUSING.
C. Swing Bearing/Worm Gear Teeth*
(S/N 0300069337 to 0300077285 USA and
S/N 1300000001 to 1300000353 Belgium)
Lube Point(s) - Grease Fitting
Capacity - A/R
Lube - Mobil SHC 460
Interval - A/R