JLG 260MRT Operator Manual - Manual (Page 31)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
3121219 – JLG Lift – 2-9
GENERAL
Begin the “Walk-Around Inspection” at Item 1, as noted on
the diagram.Continue to the right (counterclockwise viewed
from top) checking each item in sequence for the condi-
tions listed in the “Walk-Around Inspection Checklist”.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”
DURING “WALK-AROUND INSPECTION”.
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE.
CHECKING THIS AREA OFTEN RESULTS IN DISCOVERY OF CONDI-
TIONS WHICH COULD CAUSE EXTENSIVE MACHINE DAMAGE.
NOTE: On each item, make sure there are no loose or missing
parts, that they are securely fastened, and that no visible
damage exists in addition to any other criteria men-
tioned.
1. Platform Controls - Properly secured, no loose or miss-
ing parts, no visible damage. Placards secure and legi-
ble, control switches return to neutral. Control
markings legible, manual in manual storage box.
2. Steer Linkage - See Note.
3. Wheels and Tires - Properly secured, no missing lug
nuts. Refer to section 6, Tires and Wheels. Inspect
wheels for damage and corrosion.
4. Drive Motor, Left Front (4 Wheel Drive) - See Note. No
evidence of leakage.
5. Drive Brake, Left Front (4 Wheel Drive) - See Note. No
evidence of leakage.
6. Lift Cylinder - See Note.
7. Scissor Arms and Sliding Wear Pads - Properly
secured, no visible damage, evidence of proper lubri-
cation. Inspect scissor arm guards for damage and
proper installation.
8. Hydraulic Reservoir - No visible damage or missing
parts, No evidence of leaks. recommended oil level in
sight glass. Breather cap secure and working.
Figure 2-2. Walk Around Inspection Points - Sheet 1